Cutting Media - Epson SC-F9400H Series Operator's Manual

SC-F9400H Series/SC-F9400 Series Operator's Guide
C
Select Print Remaining Length and press the
Z button.
D
Press the Z button to print the amount of
media remaining.

Cutting Media

You can check the procedure in a video on YouTube.
Epson Video Manuals
Caution:
❏ The heater may be hot, so observe all necessary
precautions while doing work. Failure to
observe the necessary precautions could result
in burns.
❏ When cutting media, be careful not to cut your
fingers or hands with the cutter or other blades.
A
Press the M button, select Feed To Cut Position,
and then press the Z button.
The trailing edge of the print is fed to the cut
position (cutter groove).
Basic Operations
If you have printed the amount of media
remaining, press the u button to rewind the
media until this information appears on the roll
side beyond the cutter groove so that it will
remain on the roll after the media is cut.
B
Set the Auto switch to Off .
C
Raise the cutter, and then move it so that the
cutter blade fits the cutter groove properly.
If you cannot position your hand correctly due to
the front cover, open the front cover and then
cut.
25