SC-F9400H Series/SC-F9400 Series Operator's Guide
Ink other than high density black ink and
fluorescent ink
High density black ink and fluorescent ink
c
Important:
Press the ink inlet cap down firmly so that it
does not detach. If the slider comes into contact
with the ink inlet cap when pulling it out, the
cap could be damaged.
Maintenance
M
Close the slider ink inlet cover.
When ink adheres to the heat shield when refilling
the ink, remove the heat shield and clean it.
U User's Guide (Online Manual)
Disposing of used ink packs and chip units
"Disposal" on page 52
U
Stirring High Density
Black Ink and Fluorescent
Ink
A characteristic of high density black ink and
fluorescent ink is that sedimentation occurs easily. Stir
the following ink once a week. There may be color
differences in the printouts if printing is performed
when sedimentation has occurred.
❏ SC-F9400H Series: HDK, FY, FP
45