Epson SC-F9400H Series Operator's Manual page 12

SC-F9400H Series/SC-F9400 Series Operator's Guide
c
Important:
If the roll holder is inserted into the roll core
insufficiently, media is not fed correctly during
printing because of slippage between the roll
holder and roll core.
This may cause banding in the print results.
M
While pressing from the top of the roll holder,
tighten the fixing screw until it no longer turns.
Tighten it so the roll holder does not move.
c
Important:
If the roll holder screw is loose, the roll holder
may move during printing. This could cause
stripes and unevenness in the print results.
Basic Operations
N
Rotate the handle until part A in the illustration
below is fully inserted.
c
Important:
Once part A is hidden, do not turn the handle
any further. Failure to observe this precaution
could damage the roll holder.
If part A is still visible even after the handle has
been turned fully, rewind the handle. Loosen
the right-side roll holder's screw, and then
restart from step 4.
O
Insert the media approximately 30 cm into the
opening, then lower the media loading lever.
12