Take-Up With The Printed Side Facing In - Epson SC-F9400H Series Operator's Manual

SC-F9400H Series/SC-F9400 Series Operator's Guide
J
Leave a 10 to 20 cm wide section in the center of
the media, and cut at least 25 cm in height from
the left and right corners of the media.
Cutting the media prevents feeding problems,
such as the left and right corners of media being
folded and caught at the start of take-up.
For the subsequent steps, see the following depending
on how the media is rolled.
For information on taking-up with printed side in, see
"Take-up with the Printed Side Facing In" on
U
page 19.
For information on taking-up with printed side out, see
"Take-up with the Printed Side Facing Out" on
U
page 21.
Basic Operations
Take-up with the Printed Side
Facing In
A
While pulling the center of the media straight
down, wrap it around the roll core from back to
front, and affix it using commercially available
adhesive tape.
c
Important:
Attach the media to the take-up roll core with
the media pulled tightly. If media is attached
loosely, the media may move around during
take-up.
19