Epson SC-F9400H Series Operator's Manual page 41

SC-F9400H Series/SC-F9400 Series Operator's Guide
The ink level is lower than the top of the
rectangular cut-out sections.
Refill the ink immediately.
If the ink level falls below the top of the hole, the
ink level may be below the minimum limit and
printing may stop.
If the status of the chip unit on the control panel
is "Reserved", go to step 7. If it is not Reserved,
go to step 2.
c
Important:
When the remaining ink is 50 mm or more
from the bottom of the ink tank and a message
appears stating, Refill Ink Tank, it is time to
replace the ink tank. Replace the ink tank.
Replacements and repairs will be provided for
a fee.
During replacements and repairs, the ink in
the ink tank is discarded. This is necessary
because fine dirt, dust and other foreign bodies
mixed into the ink in the ink tank cause the ink
tank to malfunction.
The ink tank replacement interval depends on
the usage environment and conditions.
Contact your dealer or Epson Support.
B
Lift the lock lever for the slider of the chip unit
you intend to replace.
Maintenance
C
Insert a finger into the depression on the top of
the slider and pull straight outward.
c
Important:
Do not tilt the slider. If the chip unit is dropped
it may break.
D
Remove the chip unit from the slider.
41