Adjusting The Media Feed During Printing; Cutting Media - Epson SureColor F6370 User Manual

Adjusting the Media Feed During Printing

Follow the steps here to adjust the feed during printing without printing a test pattern.
1. During printing, press the
The product control panel displays an adjustment value.
2. Press the up or down arrow button to adjust the feed depending on these banding results in your
printout:
• If black bands or dark stripes appear, press the up arrow button to increase the feed amount.
• If white bands or pale stripes appear, press the down arrow button to decrease the feed amount.
3. Check the results in your printout and do one of the following:
• If further adjustment is necessary, repeat the last step.
• If the print quality is good, press the OK button.
Parent topic:

Cutting Media

When you finish printing, do one of the following to cut the media:
• If you turned on the Auto Cut setting on the product control panel, your product automatically cuts the
media after printing each page.
• If you did not turn on the Auto Cut setting, follow the instructions here to cut the media manually.
Warning: Be careful not to cut yourself when using cutters or other sharp blades.
Note: The minimum length of paper that you can cut with the built-in cutter is 2.36 inches (60 mm). If
your printed image is smaller, the built-in cutter must leave a margin that you can trim using a
commercially available cutter after removing the media from the product.
cut/feed media button.
Media Feed Adjustment
35