Chapter 4: Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service procedures, you must perform the
following procedures first.
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, please
remove all power sources.
Please wear ESD protected gloves before conducting the following steps.
Do NOT pile items on top of the system to prevent damages due to this improper use. Lanner
is not liable for damages caused by improper use of the product.
1. Power off LEC-3031-xx and remove the power cord.
2. Remove the screws from the sides and the rear, as circled in the image below.
Industrial Communication Platform
50