Canon MX860 Service Manual page 55

MX860 / MX868 --- 4. ADJUSTMENT / SETTINGS
4-3. PTT Parameter Mode
Enter the PTT parameter mode in the user mode as below. (The PTT parameter mode cannot be entered in the service mode.)
1) In the user mode, press the SCAN button to enter the scan mode.
2-a) Press #, 9, 7, 6, 9, # to enter the PTT parameter mode.
2-b) Press #, 9, 7, 6, 8, # to print the PTT parameter setting value.
How to finalize the data: Press the OK button to finalize the data, then press the Stop button to save the data.
How to exit the PTT parameter mode: Press the ON button to write the saved data to the EEPROM and turn off the
machine.
<PTT parameter mode operation procedures>
1. In the user mode, press the SCAN button to enter the scan mode and press #, 9, 7, 6, 9, #.
2. The following message is displayed on the LCD.
PTT PRAMETER
#1 BIT SWITCH
BIT SWITCH menu
3. Each time the right or left cursor button is pressed, the menu is changed.
PTT PRAMETER
#2 NUMERIC
PARAM.
NUMERIC PARAM. menu
PTT PRAMETER
#3 FAX TYPE
Note: Not used in servicing.
PTT PRAMETER
#4 NCU
Note: Not used in servicing.
PTT PRAMETER
#5 PTT SPECIAL
Note: Not used in servicing.
PTT PRAMETER
#6 FAX TEST
Note: Not used in servicing.
4. Press the OK button when "#BIT SWITCH" or "#2 NUMERIC PARAM." is displayed to enter either of those modes.
52 / 64
TABLE OF CONTENTS