Canon MX860 Service Manual page 11

Print head [1403]
temperature
sensor error.
Faulty EEPROM [1405]
data of the print
head.
Multiple ink [1487] U071 More than one ink tank
tanks of the same
color installed.
Ink tank in a [1680] U072 Some ink tanks are not
wrong position.
Warning: The [1700]
ink absorber
becomes almost
full.
The connected [2001]
digital camera or
digital video
camera does not
support Camera
Direct Printing.
Automatic duplex [1310]
printing cannot
be performed.
The remaining [1683] U130 (Applicable ink tank
ink amount
unknown (raw
ink present).
correct print head.
of the following color is
installed.
installed in place.
--- Contact the support
center or service center
for ink absorber
replacement. Press [OK]
to continue printing.
--- Incompatible device
detected. Remove the
device.
--- This paper is not
compatible with duplex
printing. Remove the
paper and press [OK].
icon)
The remaining level of
the ink cannot be
correctly detected.
head may be defective.
Replace the print head.
Replace the wrong ink tank(s)
with the correct one(s).
Install the ink tank(s) in the
correct position.
Replace the ink absorber, and
reset its counter. [See 4-5.
Special Notes on Servicing, (5)
Ink absorber counter setting.]
Pressing the OK button will
exit the error, and enable
printing without replacing the
ink absorber. However, when
the ink absorber becomes full,
no further printing can be
performed unless the
applicable ink absorber is
replaced.
Remove the cable between the
camera and the machine.
The paper length is not
supported for duplex printing.
Press the OK button to eject
the paper being used at error
occurrence.
Data which was to be printed
on the back side of paper at
error occurrence is skipped
(not printed).
An ink tank which has once
been empty is installed.
Replace the applicable ink tank
with a new one. Printing with a
once-empty ink tank can
damage the machine.
To continue printing without
replacing the ink tank(s), press
the Stop button for 5 sec. or
longer to disable the function
to detect the remaining ink
amount. After the operation, it
is recorded in the machine
EEPROM that the function to
detect the remaining ink
amount was disabled.
8 / 64
- Ink tank
- Logic board
- Ink tank
- Logic board
- Absorber kit
- PictBridge board
- Logic board
- Duplex feed roller unit
- PE sensor board
- Logic board
- Ink tank
- Spur unit