Selecting And Setting Cameras - Yealink VS800 Administrator's Manual

• Adjusting Camera Angle and Focus
• Adjusting the White Balance
• Adjusting the White Balance
• Adjusting Graphics
• Configuring Other Settings of the Camera
Allowing the Far-End System to Control Your Camera
•
Setting the Camera Presets
•
• Configuring Continuous Auto Focus

Selecting and Setting Cameras

You can select a desired camera, customize its name and set the camera layout. This feature is not applicable to VP59.
Procedure
1. On your web user interface, go to Setting > Camera > Camera.
2. Configure and save the following settings:
Parameter
Camera
Status
Multi-camera Default Layout
Description
Configure the desired camera.
Enable or disable the selected
camera.
Note: the default value id On.
It is not applicable to VC200/
VC500/PVT950.
Configure the default camera
layout when you use multiple
cameras.
The supported layouts are
described as below:
• 1+N
• Selected speaker
• Equal N×N
Note: the default value is 1+N.
It is not applicable to VC200/
VC500/PVT950.
| Configuring Camera Settings | 146
Configuration Method
Web user interface
Web user interface
Web user interface