Starting Kernel With Ramdisk Using Fat16 Partition - SMART Embedded Computing COMX-P2020 BSP User Manual

Start Linux
and then edit this message (/etc/issue) to remove this message
COMX-P2020 login: root
Password:
[root@COMX-P2020 root]#
6.3.3

Starting kernel with Ramdisk using FAT16 partition

By default the USB stick will contain FAT16 partition on partition 2, as shown in the above
table.
To boot from this FAT16 partition, execute the following command:
=> run usbfatboot
(Re)start USB...
USB: Register 10011 NbrPorts 1
USB EHCI 1.00
scanning bus for devices... 3 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
reading uImage
................................................................
........................................
3416476 bytes read
reading comx.dtb
.
9824 bytes read
reading rootfs-min.ext2.img
.......................
................................................................
...................
3473422 bytes read
WARNING: adjusting available memory to 30000000
## Booting kernel from Legacy Image at 01000000 ...
Image Name:
Created:
Image Type:
80
Linux-2.6.32
2010-09-28 2:19:17 UTC
PowerPC Linux Kernel Image (gzip compressed)
COMX-P2020 BSP User Guide (6806800L84C)
Start Linux