Program Spi Flash With Sf100 - SMART Embedded Computing COMX-P2020 BSP User Manual

Normally, you can see the following information from the serial terminal as below:
U-Boot 2009.11-V100R00 (Dec 09 2010 - 14:40:51)
CPU0: P2020E, Version: 2.0, (0x80ea0020)
Core: E500, Version: 5.0, (0x80211050)
Clock Configuration:
CPU0:1200 MHz, CPU1:1200 MHz,
CCB:600 MHz,
DDR:333.333 MHz (666.667 MT/s data rate) (Asynchronous), LBC:37.500
MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
I2C: ready
SPI: ready
DRAM:
L2: 512 KB enabled
MMC: FSL_ESDHC: 0
EEPROM: NXID v0
EEPROM: COMX
PCIE3 connected to Slot0 as Root Complex (base addr ffe08000)
PCIE3 on bus 00 - 00
PCIE2 connected to Slot 1 as Root Complex (base addr ffe09000)
PCIE2 on bus 01 - 01
PCIE1 connected to Slot 2 as Root Complex (base addr ffe0a000)
Current Status: LSR-11, LTSSM-16, PEX width-x1, Clock-2.5GT/s
PCIE1 on bus 02 - 03
In: serial
Out: serial
Err: serial
Net: eTSEC1, eTSEC2, eTSEC3
Hit any key to stop autoboot: 0
=>
5.3.3

Program SPI Flash with SF100

1. Install the driver and application of the SF100 at the Windows OS.
2. Connect the SF100 to the USB port and insert the SPI Flash into the socket of SF100.
The COMX-P2020 support the SPI Flash: S25FL032A(P)
COMX-P2020 BSP User Guide (6806800L84C)
2 GB
Scanning PCI bus 03
03 00 18ca 0027 0300 00
U-boot Deployment
43