U-Boot Command - SMART Embedded Computing COMX-P2020 BSP User Manual

U-boot Deployment
L2: 512 KB enabled
MMC: FSL_ESDHC: 0
EEPROM: NXID v0
EEPROM: COMX
PCIE3 connected to Slot0 as Root Complex (base addr ffe08000)
PCIE3 on bus 00 - 00
PCIE2 connected to Slot 1 as Root Complex (base addr ffe09000)
PCIE2 on bus 01 - 01
PCIE1 connected to Slot 2 as Root Complex (base addr ffe0a000)
Current Status: LSR-11, LTSSM-16, PEX width-x1, Clock-2.5GT/s
PCIE1 on bus 02 - 03
In: serial
Out: serial
Err: serial
Net: eTSEC1, eTSEC2, eTSEC3
Hit any key to stop autoboot: 0
=>
5.4

U-boot Command

To see a list of the available U-Boot commands, type "help" or "?". This will display a list of
all commands that are available in your current configuration. Proceed as follows:
=> help
?
at24c02 - read/write at24c02
base
bdinfo - print Board Info structure
boot
bootd
bootelf - Boot from an ELF image in memory
46
Scanning PCI bus 03
03 00 18ca 0027 0300
- alias for 'help'
- print or set address offset
- boot default, i.e., run 'bootcmd'
- boot default, i.e., run 'bootcmd'
00
COMX-P2020 BSP User Guide (6806800L84C)
U-boot Deployment