Programming Your Valve - Clean Water Systems 5900e Installation & Start?Up Manual

15. Next, you will need to program the system to work as a Neutralizer Filter. There are a few
settings that must be changed before the system can be put into service. Plug in the control
valve and begin the programming instructions.
Programming Your Valve
*While scrolling through numbers, it only increases the value. To decrease the value,
you will have to "go all the way around" to get back to a lower value.
1. To enter main menu press the Menu/Enter button
(Time of day will flash)
2. To set time of day press the Set/Change button
(First digit will begin to flash)
‐ To change digit value press the Set/Change button
‐ To accept the digit press the Menu/Enter button
‐ (Next digit will flash)
‐ (Once hours is accepted all digits will flash)
3. With all digits flashing press the Menu Button to set A.M. or P.M.
‐ (Once A.M./P.M. is accepted the next menu item will flash)
4. To Set Regeneration Frequency Press the Set/Change Button
‐ The recommended setting for a Neutralizer filter is every 7 days
‐ Once the last digit is accepted all digits will flash
Notes: ‐Maximum Value is 29
‐If value is set to 0, automatic regeneration will never occur
‐One cycle must be completed before new setting will be accepted.
5. To exit menu press the Menu/Enter button
Note: If no buttons are pressed for 60 seconds or longer the menu will
automatically be exited.
Next you will need to set the Master Programming to be used as a Neutralizer filter, continue
on to the next page to finish the programming instructions.
Page 10
5900e Neutralizer Installation & Startup Guide
www.cleanwaterstore.com
Example [ 12:00 ]
Example [ A ]
Example [ A ‐ 07 ]
Rev 072816