Programming Your Valve And Setting Time And Days For Backwash - Clean Water Systems 7500-M Installation Manual

7500-M Sediment Filter Installation & Startup Guide

Programming Your Valve and Setting Time and Days for Backwash

Next, you will need to program the system to work as a Sediment Filter. There are a few settings that
must be changed before the system can be put into service. Plug in the control valve and begin the
programming instructions.
*IMPORTANT*: Before any operation, the valve menu must be unlocked. If the button lock
indicator is displayed, press and hold both the Up and Down buttons for 5 seconds. A sound will
indicate the menu is unlocked. The menu will re‐lock automatically after 1 minute of inactivity.
1. To begin programming your valve, unlock the menu and press the Menu/Confirm button. This
puts the valve into program display mode, indicated by the Enquiry/Setting icon being
displayed. The Enquiry/Setting icon is displayed whenever you are changing the parameter
of a programming mode.
2. The sequence of programming modes is shown in the diagram below. To switch between
modes, press the up or down button according to which direction your mode is. The modes
can only be changed when the Enquiry/Setting button is displayed and you are not currently
modifying any other parameter.
8 www.cleanwaterstore.com 042021