Programming Your Valve And Setting Time And Days For Backwash - Clean Water Systems 7500-M Installation Manual

7500-M Pro-Ox Filter Installation & Startup Guide
10. Install the control valve onto the tank and tighten enough to seal the O-ring. Do not overtighten the
control valve to the tank as damage may occur.
11. Mate your Inlet, Outlet, and Drain line connections to your plumbing. If using flex lines to your inlet
and outlet connections, thread tape or sealant is not required. The fitting seals to the washer inside
the flex-line.

Programming Your Valve and Setting Time and Days for Backwash

Next, you will need to program the system to work as a Pro-Ox Filter. There are a few settings that
must be changed before the system can be put into service. Plug in the control valve and begin the
programming instructions.
*IMPORTANT*: Before any operation, the valve menu must be unlocked. If the button lock
indicator is displayed, press and hold both the Up and Down buttons for 5 seconds. A sound will
indicate the menu is unlocked. The menu will re-lock automatically after 1 minute of inactivity.
1. To begin programming your valve, unlock the menu and press the Menu/Confirm button. This
puts the valve into program display mode, indicated by the Enquiry/Setting icon being
displayed. The Enquiry/Setting icon is displayed whenever you are changing the parameter
of a programming mode.
9 www.cleanwaterstore.com rev 10-01-21