Rexroth Indramat SYSTEM200 Project Planning Manual page 78

16-2
List of Figures
Fig. 9-3: Technical data 9-2
Fig. 9-4: Pin assignment of the INTERBUS diagnosis interface X64
(RS232 C) 9-3
Fig. 9-5: Pin assignment of the INTERBUS interface X60 (remote bus)
9-3
Fig. 10-1: PROFIBUS connections 10-1
Fig. 10-2: Setting of the module type 10-2
Fig. 10-3: Pin assignment of the diagnosis interface RS232C (X74, X79)
10-4
Fig. 10-4: Pin assignment of the PROFIBUS interface (X70, X75) 10-4
Fig. 11-1: LK DNM03 11-1
Fig. 11-2: Maximum cable lengths dependent on the used cable 11-2
Fig. 11-3: Setting of the I/O address 11-2
Fig. 11-4: Pin assignment of the DeviceNet diagnostic interface X84 11-4
Fig. 11-5: Pin assignment of the DeviceNet interface X80 11-4
Fig. 12-1: P.C.B. SIO 04-B 12-1
Fig. 12-2: Jumper settings on the P.C.B. SIO 04-B 12-2
Fig. 12-3: Function blocks for interface handling 12-2
Fig. 12-4: Pin assignment of RS 232C X35, X36 12-3
Fig. 12-5: Pin assignment of RS422/485 X40, X41 12-3
Fig. 13-1: RS485 connection with INS0619 connector 13-1
Fig. 13-2: RS422 connection with INS0645 connector 13-1
Fig. 13-3: ISP200-R networking with BTV20/30 13-2
Fig. 14-1: MTS-R with compact operator terminals via an RS422 interface
14-1
Fig. 14-2: MTS-R with compact operator terminals via an RS485 interface
14-2
Fig. 14-3: MTS-R with BTC06 via an RS232 interface 14-3
Fig. 14-4: MTS-R with via an RS422 interface 14-4
Fig. 15-1: MTS-R accessories 15-3
Fig. 15-2: Labeling accessories 15-4
RECO PLC ISP200-R/G2
DOK-CONTRL-MTS-R0*.2G2-PR01-EN-P