RAM 1500 2020 Owner's Manual page 344

342 IN CASE OF EMERGENCY
Front Jacking Location
When changing a front wheel, place the
scissor jack under the rear portion of the
lower control arm as shown. Access the
front jacking location from behind the front
tire.
Front Lifting Point
Front Jacking Location
Rear Jacking Location
When changing a rear wheel, assemble the
extension with jack hook to the jack and
connect the extension tubes. Access the
rear jacking location from behind the rear
tire. Place the jack under the Jack Lifting
Point located on the rear axle lower control
arm bracket. Then locate the slot in the jack
lift plate onto the rear axle Jack Lifting Point.
Attach the extension with jack hook extend-
ing to the rear of the vehicle.
Rear Lifting Point
Rear Jacking Location
Connect the long extensions to the lug
wrench.
CAUTION!
Before raising the wheel off the ground, make
sure that the jack will not damage surround-
ing truck parts and adjust the jack position as
required.
5. By rotating the lug wrench clockwise, raise
the vehicle until the wheel just clears the
ground surface.