RAM 1500 2020 Owner's Manual page 290

288 STARTING AND OPERATING
Front Cross Path View
Pressing the Front Cross Path soft
key will give the driver a wider angle
view of the front camera system. The
Top view will be disabled when this is
selected.
Rear View Camera
Pressing the Backup Camera soft key
will provide a full screen rear view with
Zoom View.
NOTE:
If the Backup Camera view was selected
through the Surround View Screen, exiting out
of the Rear View Camera screen will return to
the Surround View Screen. If the Backup
Camera was manually activated through the
Controls menu of the Uconnect display, exiting
out of the display screen will return to the
Controls menu.
Zoom View
When the Rear View Camera image is being
displayed, and the vehicle speed is below
8 mph (13 km/h) while in any gear selector
position, Zoom View is available. By pressing
the "magnifying glass" icon in the upper left of
the display screen, the image will zoom in to
four times the standard view. Pressing the icon
a second time will return the view to the
standard Backup Camera display.
When Zoom View is selected while the vehicle is
in REVERSE, then shifted to DRIVE, the camera
delay view will display the standard Backup
Camera view. If the vehicle is then returned to
REVERSE gear from DRIVE, the Zoom View
selection will automatically resume.
Shifting to NEUTRAL from any gear will maintain
the selected view (Zoom or Standard) as long as
the vehicle is below 8 mph (13 km/h).
If the vehicle is in PARK, Zoom View is available
until the gear selector is placed in DRIVE or
REVERSE and speeds are at or above 8 mph
(13 km/h).
NOTE:
If the vehicle is in DRIVE, NEUTRAL, or

REVERSE, and speed is greater than or equal
to 8 mph (13 km/h), Zoom View is unavail-
able and the icon will appear grey.
While in Zoom View, the guidelines will not be

visible.
Deactivation
The system is deactivated in the following
conditions if it was activated automatically:
When the vehicle is shifted out of REVERSE

(with camera delay turned on), the camera
image will continue to be displayed for up to
10 seconds after shifting out of REVERSE
unless the vehicle speed exceeds 8 mph
(13 km/h), the vehicle is shifted into PARK or
the ignition is placed in the OFF position.
There is a touch screen button "X" to disable
the display of the camera image.
When the vehicle is shifted out of REVERSE

(with camera delay turned off), the surround
view camera mode is exited and the last
known screen appears again.
The system is deactivated in the following
conditions if it was activated manually from the
Uconnect controls menu via Surround View
button or Backup Camera button:
The "X" button on the display is pressed

Vehicle is shifted into PARK

Ignition is placed in the OFF position

Vehicle speed is over 8 mph (13 km/h) for

10 seconds