RAM 1500 2020 Owner's Manual page 240

238 STARTING AND OPERATING
The indicator lamps 1 through 5 will illuminate
to show the current position of the vehicle.
Flashing indicator lamps will show a position
which the system is working to achieve. When
raising, if multiple indicator lamps are flashing,
the highest flashing indicator lamp is the
position the system is working to achieve. When
lowering, if multiple indicators are flashing, the
lowest solid indicator lamp is the position the
system is working to achieve.
Pushing the height selector up once will move
the suspension one position higher from the
current position, assuming all conditions are
met (i.e. key in ON/RUN position, engine
running, speed below threshold, etc). The
height selector switch can be pushed up
multiple times, each push will raise the
requested level by one position up to a
maximum position of OR2 or the highest
position allowed based on current conditions
(i.e. vehicle speed, etc).
Pushing the height selector down once will
move the suspension one position lower from
the current level, assuming all conditions are
met (i.e. key in ON/RUN position, engine
running, doors closed, speed below threshold,
etc). The height selector switch can be pushed
down multiple times, each push will lower the
requested level by one position down to a
minimum of Entry/Exit Mode or the lowest
position allowed based on current conditions
(i.e. vehicle speed, etc.)
Automatic height changes will occur based on
vehicle speed and the current vehicle height.
The indicator lamps and instrument cluster
display messages will operate the same for
automatic changes and user requested
changes.
Off-Road 2 (OR2) – Indicator lamps 5, 4, 3, 2

and 1 will be illuminated when the vehicle is
in OR2.
Off-Road 1 (OR1) – Indicator lamps 5, 4, 3

and 2 will be illuminated when the vehicle is
in OR1.
Normal Ride Height (NRH) – Indicator lamps

5, 4 and 3 will be illuminated when the
vehicle is in this position.
Aero Mode – Indicator lamps 5 and 4 will be

illuminated when the vehicle is in this posi-
tion.
Entry/Exit Mode – Indicator lamp 5 will be illu-

minated when the vehicle is in Entry Exit
Mode. Entry/Exit mode can be requested up to
33 mph (53 km/h). If vehicle speed is reduced
to, and kept below, 15 mph (24 km/h) indi-
cator lamp 4 will flash and indicator lamp
5 will remain solid until Entry/Exit Mode is
achieved at which point indicator lamp 4 will
turn off.
Transport Mode – No indicator lamps will be

illuminated. Transport Mode is disabled by
driving the vehicle.
Tire/Jack Mode – Indicator lamps 5 and 1 will

be illuminated. Tire/Jack Mode is disabled by
driving the vehicle.
Wheel Alignment Mode – Indicator lamps 3,

4, and 5 will be illuminated. Wheel Alignment
Mode is disabled by driving the vehicle.