RAM 1500 2020 Owner's Manual page 327

Rear Tail/Stop, Turn Signal And Backup
Lamps
1. Remove the two screws and push pins
retainers that pass through the bed sheet
metal.
Tail Lamp Locations
1 — Tail Lamp
2 — Fasteners
3 — Push - Pin Retainers
2. Pull the outboard side of the lamp rearward
far enough to unsnap the two receptacles
on the outboard side of the lamp housing
from the two plastic snap post retainers in
the outer box side panel.
Tail Lamp Removed
1 — Tail Lamp Housing
2 — Bulb Socket Locations
3. Disconnect the wiring harness connectors
from the bulb socket.
Wiring Harness Connector
IN CASE OF EMERGENCY
4. Rotate the bulb socket counterclockwise a
quarter turn to unlock it from the housing.
5. Pull the bulb straight out of the socket.
CAUTION!
Do not contaminate the bulb glass by touch-
ing it with your fingers or by allowing it to con-
tact other oily surfaces. Shortened bulb life
will result.
6. Reverse the procedure to install the bulb
and housing.
325
6