RAM 1500 2020 Owner's Manual page 213

WARNING!
Driver inattention could lead to failure to

place the vehicle in PARK. ALWAYS DO A
VISUAL CHECK that your vehicle is in PARK
by verifying that a solid (not blinking) "P" is
indicated in the Instrument Cluster Display
and near the gear selector. If the "P" indi-
cator is blinking, your vehicle is not in
PARK. As an added precaution, always
apply the parking brake when exiting the
vehicle.
AutoPark is a supplemental feature. It is not

designed to replace the need to shift your
vehicle into PARK. It is a back up system
and should not be relied upon as the
primary method by which the driver shifts
the vehicle into PARK.
If the vehicle is not in PARK and the driver turns
off the engine, the vehicle may AutoPark.
AutoPark will engage when all of these
conditions are met:
Vehicle is equipped with a rotary shifter and

an 8-speed transmission
Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

Ignition switched from RUN to ACC

NOTE:
For Keyless Enter-N-Go equipped vehicles, The
engine will turn off and the ignition switch will
change to ACC mode. After 30 minutes the igni-
tion switches to OFF automatically, unless the
driver turns the ignition switch OFF.
If the vehicle is not in PARK and the driver exits
the vehicle with the engine running, the vehicle
may AutoPark.
AutoPark will engage when all of these
conditions are met:
Vehicle is equipped with a rotary shifter and

an 8-speed transmission
Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

Driver's seat belt is unbuckled

Driver's door is ajar

Brake pedal is not depressed

The MESSAGE "AutoPark Engaged Shift to P
then Shift to Gear" will display in the instrument
cluster.
STARTING AND OPERATING
NOTE:
In some cases the ParkSense graphic will be
displayed in the instrument cluster, causing the
"AutoPark Engaged Shift to P then Shift to Gear"
to not be seen. In these cases, the gear selector
must be returned to "P" to select desired gear.
If the driver shifts into PARK while moving, the
vehicle may AutoPark.
AutoPark will engage ONLY when vehicle speed
is 1.2 mph (1.9 km/h) or less.
The MESSAGE "Vehicle Speed is Too High to
Shift to P" will be displayed in the instrument
cluster if vehicle speed is above 1.2 mph
(1.9 km/h).
WARNING!
If vehicle speed is above 1.2 mph (1.9 km/h),
the transmission will default to NEUTRAL until
the vehicle speed drops below 1.2 mph
(1.9 km/h). A vehicle left in the NEUTRAL
position can roll. As an added precaution,
always apply the parking brake when exiting
the vehicle.
211
5