Table of Contents
Advertisement
Fitting axles with roller rings
Ensure no personnel are within the machine's extension radius when activat-
ing hydraulics.
Do not activate hydraulics if there are personnel within machine extension
radius.
Replacing axles, bearings or roller rings
1. Slacken bearing screws (A) and
2. Slacken stop ring bolts (B) and
3. Withdraw roller rings from axle
4. Reverse order to reassemble
5. Apply Loctite to bearing screws
Crosskill ring
1. Position axles with roller rings and bearings corresponding to that
when Maxiroll is extended, resting on the ground.
2. Extend roller and carefully lower over the axles.
3. Fit bolts (A)
withdraw bearings
withdraw stop rings.
Note axle direction of rotation.
1. After the outer stop ring (
2. Fig. B) there is a smaller
ring.
3. Fit bushing (A)
4. Fit large ring (B)
5. Finish off with a small ring,
and then fit a stop ring.
Maxiroll 2008
Fig. 33
B
Fig. 104
A
B
A
Tromle midt
Page 35
Advertisement
Table of Contents
