Replacing Gaskets For Side Section Fold/Unfold - DAL-BO Maxiroll 1030 2008 Manual

Activate extend/retract cylinders after fitting until they show a little move-
ment. Reverse cylinders until they return to start position. Move cylinders
backwards and forward several times. Raise roller fully onto wheels, extend
side sections fully to bleed system.
Ensure no personnel are within the extension radius of the side sections.

Replacing gaskets for side section fold/unfold

Fig. 24
1. For cylinder removal, see "Replacing extend cylinder for folding side sec-
2. Drain oil from cylinder by moving ram carefully backwards and forwards.
3. Extend ram to centre position. Unscrew upper part (pos. 3) from cylinder
4. Remove lock nut securing collar show (pos. 4).
5. Remove collar shoe (pos. 4) from ram.
6. Remove upper part (pos. 3) from ram.
7. Remove gaskets in upper part and collar shoe, (pos. 5+6+7+8+9).
8. Clean all parts and check for particles etc. Check for rust around scraper
Page 28
Maxiroll 2008
tions".
tube (pos. 1). Use special tool to remove upper part. If upper part is stuck,
heat front of sleeve. When upper part is detached from cylinder tube, pull
ram up towards upper part and remove completely from cylinder tube.
ring (pos. 5) in upper part. If detected, remove thoroughly.