Fault
Cause
Mid-section apply-
ing too much pres-
sure
Side section ex-
tremities applying
too much pressure
Pressure on ma-
nometer dropping
Side sections not
following terrain
Maxiroll 2008
Troubleshooting
Insufficient pres-
sure
transferred
to side sections
Drawbar too high
Mid-section not
horizontal
Insufficient pres-
sure
in
mid-
section
Drawbar too low
Mid-section not
horizontal
Handle
not
in
flow setting
Driver-operated
non-return valve
defective
Cylinder (gasket
set) leaking
Weight
transfer
hydraulic system
not in flow set-
ting
Remedy
Activate hydraulic control handle
for extend/retract to increase pres-
sure
to
side
"Operation").
Adjust drawbar and mid-section
(see "Adjusting drawbar height"
page 13.
Adjust drawbar and mid-section
(see "Adjusting drawbar height"
page 13.
Activate hydraulic control handle
for extend/retract to increase pres-
sure
to
"Operation").
Adjust drawbar and mid-section
(see "Adjusting drawbar height"
page 13.
Adjust drawbar and mid-section
(see "Adjusting drawbar height"
page 13.
Adjust pressure on weight transfer
and set handle to flow setting (see
"Adjustment of hydraulic weight
transfer")
Set weight transfer to 15 bar, set
handle to flow setting. Leave
Maxiroll standing for 30 mins. If
pressure drops, the driver-operated
non-return valve is defective, or
there may be dirt in the valve (dis-
assemble valve and clean parts)
Set hydraulic weight transfer in
flow setting (see "Adjustment of
hydraulic weight transfer")
sections
(see
mid-section
(see
Page 19