Removing Blade Roller; Replacing Blade Roller Bearings; Fitting Bearings - DAL-BO MaxiCut 200 Instruction Manual

Removing blade roller

Repairs must be performed with the roller connected to a tractor, resting on a
level surface, fully extended with the 3 rollers resting on the ground. A crane
or similar is recommended for removal and replacement procedures.

Replacing blade roller bearings

If no crane is available, remove both side section axles to prevent roller tip-
ping over.
1. All 3 sections must rest on the
2. Slacken bolts (A) at each end of
3. Activate wheel frame cylinder
4. The bearing can now be with-

Fitting bearings

1. Push bearing into axle. Tighten the two 12 mm bolts and the large clamp
2. Activate wheel frame cylinder and lower frame towards bearing. Fit bolt
Ensure no personnel are within the machine's extension radius when activat-
ing hydraulics.
Side 26
ground!
tank.
to raise machine onto wheels.
drawn when bolts (B) are re-
moved.
plate.
(A) and tighten.
MaxiCut
Fig. 13
A
B