Correct operation is vital to get the best out of your Maxiroll 2008 1030 or
1230. This applies to field use and safety. Always ensure you are fully familiar
with all safety aspects of the machine.
Extending and folding up
Extending and folding the machine up must always be performed with tractor
parked.
Before extension and folding, check crackerboard is fully raised to avoid teeth
colliding (see "Accessories, Crackerboard")
Extending
1 Side sections are lifted from the
2 Activate extend/retract cylinders
3 Activate raise/lower cylinders to
Before starting rolling, ensure weight transfer is correctly adjusted (see
"Adjustment of hydraulic weight transfer").
Page 14
Maxiroll 2008
Operation
transport
bar
(A)
raise/lower
cylinder
White).
(marked: Red) to fully extend
side sections.
lower roller to ground. While the
roller is getting lower is it very
important, that the two outer
shafts and the middle shaft are
hitting the ground exactly at
the same time, so the middle
section won´t get overloaded.
Set raise/lower cylinder to flow
setting last.
Fig. 4
using
(marked:
Fig. 5
A