Adjustment; Adjustment Of Rollers; Wheels; Wear Parts - DAL-BO Maxiroll 1030 2008 Manual

Adjustment

Adjustment of rollers

After the first season, the rollers will have loosened on the shaft. Play can be
eliminated by moving the stop rings on the shaft.
Adjustment is easiest when Maxiroll is folded together.
1 Slacken bolts (A) and push roll-
2 Tighten and slacken stop ring

Wheels

Lubricate and adjust wheel bearings at least once annually. Check tyre pres-
sures at least once annually (see recommended pressure on tyre).
Adjustment and lubrication of wheel bearings
1. Remove hub caps.
2. Remove split pin.
3. Tighten castle nut 1/6th of a turn until hole aligns with axle. Turn wheel,
4. Replace split pin
5. Fill hub cap ¾ full with grease. Replace.

Wear parts

ers together
bolts at the same place on the
shaft several times to ensure they
bite firmly into the shaft.
check for resistance. A little play should be detected in the hub housing
when rocking wheel from side to side. If play is excessive, repeat process.
Wear parts (shoes) are factory-
mounted in the upper holes on each
tooth. Move down to the lower holes
(A) before teeth are worn.
Once they are worn out (when in the
lower holes), replace.
Maxiroll 2008
Fig. 21
Fig. 22
A
A
Page 25