Table of Contents
Advertisement
Mounting
1 Fit new gaskets in upper part and collar shoe.
2 Lubricate thread in upper part (pos. 3) and cylinder tube (pos. 1) with
3 Fit upper part (pos. 3) on ram shaft.
4
5 Lubricate outer collar shoe gasket in contact with cylinder tube and inside
6 Fit upper part onto cylinder tube and tighten.
7 For fitting cylinder see "Replacing crackerboard depth-adjustment cylin-
Removal/fitting wheel
Before removing wheel, fully extend roller with rings resting on ground.
Wheels will then be raised free of ground.
Remove wheel nuts. Remove wheel. Replace wheel, hand-tighten wheel nuts.
Lower wheels to ground. Tighten wheel nuts to 300 Nm.
Ensure wheel nuts and wheel surfaces are clean to avoid nuts loosening.
Replacing wheel bearings
1. Remove hub cap pos. 21.
2. Remove split pin pos. 20.
3. Remove castle nut pos. 19.
4. Hub housing can now be re-
5. Remove bearings pos. 17+18.
6. Remove seal ring pos. 19.
Mounting
Maxiroll 2008
grease or oil.
Fit collar shoe (pos. 4) and secure ram shaft (pos. 2) with Loctite. Ensure
that thread is absolutely clean and free of oil or other impurities before ap-
plying Loctite. Do not fill with oil for 12 hours after use of Loctite.
of cylinder tube with oil, push ram into centre position.
der".
moved from shaft.
1. Fit bearing outer rings pos. 17+18 in hub housing pos. 22
2. Fit seal ring pos. 16.
Fig. 31
Page 33
Advertisement
Table of Contents
