Setting Up; Adjusting Drawbar Height; Driving And Operation; Extending And Retracting - DAL-BO Rollomaximum XL Manual

Rollomaximum is supplied with factory settings, but fine adjustment will al-
ways be required before use. Numerous adjustment options make the machine
more flexible and optimise its use.
To ensure that the ground is uniformly worked, the drawbar must be correctly
aligned to the tractor used.

Adjusting drawbar height

Supported on a level concrete floor
or similar, the machine is folded out
to
transport wheels (A) raised free.
The crackerboard (B) and harrow
section (C) are also raised, so that
the machine is now only supported
by the two compaction sections. In
this position, the entire drawbar
shaft (D) should be level. If it is not
so, the assembly should be adjusted
by the drawbar eye (E) and flange
plate (F) until the drawbar shaft is
horizontal.
Correct operation is vital to get the most out of the Rollomaximum. This ap-
plies to working in the field and to safety. Always ensure you are fully famil-
iar with all safety features of the machine.

Extending and retracting

Extending and retracting the machine must always be performed with
the tractor parked, and on a level surface.
Page 14
Rollomaximum XL

Setting up

working position and

Driving and operation

D
the
E
A
B
C
Horizontal
F