Installing The Dc-In - Dell Latitude 5401 Service Manual

Installing the DC-in

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the DC-in and provides a visual representation of the installation procedure.
Steps
1. Locate the DC-in slot on your computer.
2. Insert the DC-in port into the slot on your computer.
3. Connect the DC-in cable to the connector on the system board.
4. Place the DC-in metal bracket on the DC-in port.
5. Replace the two screws (M2x5) that secure the DC-in metal bracket to the system board.
Next steps
1. Install the heatsink-discrete.
2. Install the battery.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
46 Disassembly and reassembly