Installing The Display Assembly - Dell Latitude 5401 Service Manual

Steps
1. Remove the two (M2x3) screws that secure the EDP metal bracket to the computer.
2. Peel the tape that secures the display cable to the system board.
3. Open the latch and disconnect the display cable from the system board.
4. Disconnect the touchscreen cable from the connector on the system board.
5. Unroute the WLAN and WWAN cables from the retention clips.
6. Remove the four (M2.5x5) screws that secure the display hinges to the chassis of your computer.
7. Open the display hinges at an angle of 90 degrees and slightly open the display.
8. Remove the palm-rest and keyboard assembly off the display assembly.

Installing the display assembly

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the component and provides a visual representation of the installation procedure.
Disassembly and reassembly 69