Installing the battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the battery and provides a visual representation of the installation procedure.
Steps
1. Place the battery on the palmrest and align the screw holes on the battery with the screw holes on the palmrest.
2. Install the single (M2x6) captive screw to secure the battery to the palmrest.
3. Connect the battery cable to the connector on the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
WLAN card
Removing the WLAN card
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
24
Disassembly and reassembly
After working inside your
computer.
Before working inside your
computer.