Power button
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
2280 SATA
5. Remove the memory.
6. Remove the
WLAN
card.
7. Remove the
WWAN
card.
8. Remove the
inner
frame.
9. Remove the
LED
board.
10. Remove the DC-in.
11. Remove the
system
board.
NOTE:
System board can be removed with heatsink attached.
About this task
The figure indicates the location of the power button with fingerprint reader and provides a visual representation of the removal
procedure.
Steps
1. Locate the power button with fingerprint reader on your computer.
2. Remove the two (M2x2) screws that secure the power button to the palmrest.
3. Lift the power button with fingerprint out of the computer.
Installing the power button with fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Before working inside your
SSD.
computer.
Disassembly and reassembly
65