Installing The Dc-In - Dell P118G Service Manual

Steps
1. Locate the DC-in port on your computer.
2. Remove the single (M2x3) screw and lift metal bracket covering the display connector.
3. Remove the three (M2.5x5) screws and lift the hinge.
4. Disconnect the DC-in cable from the computer and remove the single (M2x3) screw.
5. Remove the DC-in port from the computer.

Installing the DC-in

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the DC-in port and provides a visual representation of the installation procedure.
Steps
1. Locate the DC-in port on your computer.
2. Install the (M2x3) screw and connect the DC-in cable to the system board.
50 Disassembly and reassembly