Installing The Dc-In - Dell Latitude 5501 Service Manual

Steps
1. Locate the DC-in port on your computer.
2. Remove the two (M2x5) that secures the DC-in and USB Type-C metal bracket.
NOTE: The DC-in and USB Type-C bracket is adhered to the system board with an adhesive. Use the plastic scribe to
pry and release the adhesive between the bracket and the system board, and then rotate the bracket upward to release
its hooks from the system board.
3. Lift the DC-in and USB Type-C metal bracket from the computer.
4. Disconnect the DC-in cable from the system board.
5. Remove the DC-in port from the computer.

Installing the DC-in

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the DC-in and provides a visual representation of the installation procedure.
38 Disassembly and reassembly