Table of Contents
Advertisement
The CPW90 registers with the IP phone automatically.
Unregistering the CPW90
Procedure:
1. Navigate to Settings > Wireless Microphone
2. Select the desired microphone and then tap Detail
3. Tap Unbind to deregister the CPW90
Muting or unmuting the CPW90
Procedure:
1. Tap the Mute key to mute the call. The mute LED indicator
will glow solid red. The
of the IP phone
2. Tap the Mute key again to unmute the call. The mute LED
indicator will glow solid green. The
from the status bar of the IP phone
3. On the MIC screen, tap the dropdown list "Synchronous
mode" or "Standalone mode".
• Standalone mode—Will mute or unmute speakers
interdependently
• Synchronous mode—Will mute or unmute all speakers
Idle mode
When the CPW90 registers with the IP phone successfully, the
CPW90 enters the idle mode. You can tap the Mute key on the
CPW90; the battery LED indicator on the CPW90 glows solid
green for three seconds and then goes out.
Viewing CPW90 information
When the CPW90 is registered with the IP phone, you can view
CPW90 status on the IP phone.
Available information for the CPW90 includes:
• Registration status
• Mic model
• MICPOD IPEI
• Battery level (in percent)
• Standby time (estimated standby time)
• Work time (estimated working time)
Procedure:
1. Navigate to Settings > Basic Settings > MIC
2. Tap Detail on the desired microphone block
Finding the CPW90
You can find the CPW90 that has registered with the
IP phone.
icon will appear on the status bar
icon will disappear
Procedure:
1. Navigate to Settings > Basic Settings > MIC
2. Tap Find on the desired microphone block
The mute key LED indicator on the registered CPW90 will flash
red and green alternately.
Charging the CPW90
Procedure:
1. Put the CPW90 on the charging cradle
2. Connect the micro USB port on the charging cradle to the
USB port on the phone using a 0.3 m micro USB cable
Note: If it is your first time using the CPW90, you need to fully
charge the battery before use. If the CPW90 is not in use, we
recommend you leave the device on charge, even if the battery
is full.
If your system administrator disables the USB port of the
phone, the phone cannot power the USB port.
CPW90 LED instructions
The following table shows the status indicated by the
Mute button indicator LED on the CPW90 wireless
expansion microphone.
LED status
Description
The phone enters the predialing screen.
Solid green
The phone is in a call and unmuted.
Slowly flashing red
The phone is receiving an incoming call.
Solid red
The phone is muted.
The CPW90 has registered with the phone, but the CPW90
is out of range.
Fast flashing yellow
The CPW90 has registered with the phone, but the CP960
is turned off.
Flashing red and green
The phone is searching for the CPW90 that has registered
alternatively
with it.
Off
The CPW90 is in the idle mode.
User guide
49
Advertisement
Table of Contents
