5. Twist the air cooler counter-clockwise about 1/2 inch, making sure
6. Plug the 3-pin connector into the 3-pin header (J18) on the
The air cooler is ready to work.
Connection to Peripherals
With the I/O shield in place, the PATX3070 motherboard installed in a
chassis, and modules installed on the PATX3070, you are ready to connect
peripherals and apply power to the board.
Figure 1-2 on page 1-8
They are also listed in
connectors.
For the pin assignments of the connectors listed, refer to
Connector Pin
http://www.motorola.com/computer/literature
b
the spring clip features are securely seated over the socket tabs.
Verify the heat sink is firmly locked in place.
motherboard.
shows the locations of the various cable connectors.
Table 1-3 on page 1-26
Assignments.
Hardware Installation
a
with the rest of the
Chapter 4,
1
1-25