Introduction - Motorola PATX3070 Series Installation And Use Manual

1Hardware Preparation and

Introduction

The PATX3070 is an Intel Architecture ATX form factor computer
motherboard targeted to run Windows NT
and LynxOS
the Intel Pentium
Features of the full-function PATX3070 include the following:
Note
®
, in an embedded environment. The PATX3070 is based on
®
III or Celeron
Intel 440BX chipset with support for 66/100 MHz processor-side
bus
four 3.3V DIMM slots (with support for up to 1GB SDRAM)
10BaseT/100 BaseTX Ethernet Interfaces (single or dual population
options)
two Ultra ATA/33 EIDE interface connectors, supporting up to four
hard drives
CompactFlash Type II socket
TM
dual-channel Wide Ultra SCSI interface with optional RAID
support
two RS-232 serial ports, parallel, floppy, PS/2 keyboard/mouse
support and IrDA header
watchdog, interval timers, hardware monitor
one 2x AGP slot, two 32-bit/33 MHz PCI slots, five 32-bit/33 MHz
PCI slots if configured with additional PCI-to-PCI bridge (one
shared if PCI-to-PCI bridge option used), and two ISA expansion
slots (one shared if PCI-to-PCI bridge option used).
Please see the table in the
section for a list of model numbers.
Installation
® ®
, QNX , VxWorks
processor for the PGA370 socket.
TM
About This Manual on page -xiii
1
® ®
, Linux ,
1-1