Henny Penny Evolution Elite EEE-141 Operator's Manual page 77

Menu Step
being the loudest) and the seconds volume shows in the right display.
To select the volume, press the ✓ button under the desired volume.
SP-18 Energy Save Press and release the right arrow button until "SP-18 ENERGY SAVE
Mode ENABLED?" flashes in the left display. press the up and down arrow
buttons to choose "YES" or "NO". If set to "YES", during times of non-
use, the fryer automatically starts an Energy Save Mode, which turns
off the blowers. Then once a product is selected to start a cook
cycles, the blowers and heat come back on. If set to "NO", the blow-
ers are on constantly.
SP-19 Fryer Type Press and release the right arrow button until "SP-19 FRYER TYPE"
flashes in the left display. Press the up or down buttons to choose
"GAS" or "ELEC".
SP-20 Vat Type Press and release the right arrow button until "SP-20 VAT TYPE"
flashes in the left display. Press the up and down arrow buttons to
choose "SPLIT" or "FULL".
SP-21 Auto-Lift Press and release the right arrow button until "SP-21 AUTOLIFT EN-
Enabled ABLED?" flashes in the left display. Press the up and down arrow but-
tons to choose "YES LIFT" or "NO LIFT". If fryer is fitted with the auto-
lift option, SP-21 must be set to "YES LIFT", otherwise, set SP-21 to
"NO LIFT".
SP-22 Bulk Oil Press and release the right arrow button until "SP-22 BULK OIL SUP-
Supply PLY?" flashes in the left display. Press the up and down arrow but-
tons to choose "YES SUPL" or "NO SUPL". Set to "YES" if the oil is
pumped into the vat from an outside oil reservoir. Otherwise, set SP-
22 to "NO".
SP-23 Bulk Oil Press and release the right arrow button until "SP-23 BULK OIL DIS-
Disposal POSE?" flashes in the left display. Press the up and down arrow but-
tons to choose "YES DISP" or "NO DISP". Set to "YES DISP" if the oil
is pumped from the vats to an outside oil reservoir when discarding
the oil. Otherwise, set SP-23 to "NO DISP".
SP-24 Serial Num- Press and release the right arrow button until "SP-24 S/N ✓EDIT"
ber Log flashes in the displays, along with the serial number of the unit.
I I N N F F O O : This serial number should match the serial number on the data
plate, on the doors. If not, it can be recorded.
SP-25 Program This allows the operator to change the program code (factory set at 1,
Code Change 2, 3) used to access Product Programming and Level 2 Program
Mode. Press and release the right arrow button until "SP-25 CHANGE
MGR CODE? 1=YES" flashes in the display. Press product button 1
and "ENTER NEW CODE, P=DONE, I=QUIT" scrolls through the dis-
play. Press the product buttons for new code. If satisfied with the
code, press the program button and "REPEAT NEW CODE, P=
DONE, I=QUIT" shows in display. Enter the same code you previ-
ously entered. If satisfied with code, press the program button and
"CODE CHANGED*" shows in display. If not satisfied with code,
press the info button and "*CANCEL*" shows in display, then reverts
Description
65