Henny Penny Evolution Elite EEE-141 Operator's Manual page 42

Press ✓ button and "IS DISPOSAL UNIT IN PLACE?" "YES NO" shows in
4 4 ) )
display.
With discard shuttle rolled into place (Figure 3), press ✓ button and display
5 5 ) )
shows "OPEN DRAIN". Pull-out on drain knob to open drain and display shows
"DRAINING". Oil now drains from the vat into the shuttle.
Display shows "VAT EMTY "YES NO". Verify that vat is empty, and press ✓
6 6 ) )
button.
Display shows "CLEAR OLD OIL FROM OIL LINES" "✓=PUMP" "X= DONE".
7 7 ) )
Press and hold ✓ button for a few seconds to clear old oil from lines. Once
cleared, press "X" button.
Display shows "CLN VAT COMPLETE" "YES NO". Once vat is clean, press ✓
8 8 ) )
button and display shows "CLOSE DRAIN". Push-in on the drain knob.
Display shows "MANUAL FILL POT", followed by "IS POT FILLED?", along with
9 9 ) )
"YES NO". Fill vat to the lower indicator line on the rear of the vat. See
Or Adding Oil , page
Remove the discard shuttle from under fryer and replace with the filter pan
1 1 0 0 ) )
assembly.
3 3 . . 1 1 3 3 . . 2 2 A A u u t t o o m m a a t t i i c c
Open center door, pull the drain pan assembly from under fryer and replace with
1 1 ) )
oil discard shuttle.
Press and hold the filter button (on either side) until display shows "*FILTER
2 2 ) )
MENU*", along with "1.AUTO FILTER?".
Press and release the down arrow button twice until display shows "3.
3 3 ) )
DISPOSE". Press ✓ button and display shows "DISPOSE?" "YES NO". (If
control suspects oil in drain pan "CAUTION IS THERE OIL IN PAN? YES NO"
may show in display. Make sure drain pan is empty before proceeding.)
Press ✓ button and display shows "IS DISPOSAL UNIT IN PLACE? "YES NO".
4 4 ) )
With discard shuttle rolled into place, press ✓ button and display shows
5 5 ) )
"DRAINING". Oil now drains from the vat into the shuttle.
Display shows "VAT EMTY, along with "YES NO". Verify that vat is empty, and
6 6 ) )
press ✓ button. Display shows "CLEAR OLD OIL FROM OIL LINES" "✓=PUMP"
"X=DONE". To make sure no old oil remains in the oil lines, press and hold ü
button for a few seconds. Once lines are clear, press "X" button.
Display shows "CLN VAT COMPLETE" "YES NO". Once vat is clean, press ✓
7 7 ) )
button.
Display shows "MANUAL FILL POT", followed by "IS POT FILLED?" "YES NO".
8 8 ) )
Fill the vat to the lower indicator line on the rear of the vat. Press ✓ button and
controls return to normal operation.
Remove the discard shuttle from under fryer and replace with the filter pan
9 9 ) )
assembly.
30
15. Press ✓ button and fryer returns to normal operation.
3.3 Filling