Oil; Spark Plug - Husqvarna LB248S Workshop Manual

2. Remove the wire from the bail arm.
3. Remove the 4 screws and the two washers. Remove
the rear cover.
4. Use pliers to remove the wire from the bracket.
Remove the wire from the gearbox.
510 - 001 -
7.11.4 To assemble the wires
1. Assemble in the opposite sequence. Make sure to
use the correct torque. Refer to
LB348SI on page 11 .

7.12 Oil

7.12.1 To change the engine oil
WARNING: Engine oil is very hot directly after
the engine is stopped. Let the engine become
cool before you drain the engine oil. If you spill
engine oil on your skin, clean with soap and
water.
1. Operate the product until the fuel tank is empty.
2. Remove the ignition cable from the spark plug.
3. Remove the oil tank cap.
4. Put a container below the product to collect the
engine oil in.
5. Tilt the product to drain the engine oil from the oil
tank. Make sure the air filter is in the highest
position.
6. Tilt the product to its horizontal position.
7. Fill with new engine oil of the type recommended.
Technical data on page 27 .
Refer to

7.13 Spark plug

7.13.1 To disassemble the spark plug
LB248S , LB253S,
Repair instructions - 23