3 Prepare and do servicing on the product
3.1 Assembly
3.1.1 Introduction
This section describes how to assemble and adjust the
product.
WARNING: Before you assemble the product,
read the safety chapter and the assembly
instructions.
3.1.2 To assemble the handle
1. Loosen the two lower knobs and raise the handle.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product.
3. Set the handle height in one of the 2 available
positions on the ends of the handle. Make sure to
set the same height on both sides.
6 - Prepare and do servicing on the product
4. Move the knobs up in the direction of the handle
until they stop at the top of the groove in the handle.
5. Tighten the knobs fully.
3.1.3 To set the product in transport position
1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product.
510 - 001 -