Start Inhibitor; Mulch Door And Frame; Wires - Husqvarna LB248S Workshop Manual

1. Adjust the clutch wire with the adjustment screw. To
increase tension on the wire and increase the
speed, turn the adjustment screw counterclockwise.
7.8.2.1 To assemble the drive belt
1. Assemble in the opposite sequence. Make sure to
use the correct torque. Refer to
LB348SI on page 11 .

7.9 Start inhibitor

7.9.1 To disassemble the start inhibitor
1. Remove the 2 screws. Remove the start inhibitor.
7.9.2 To assemble the start inhibitor
1. Assemble in the opposite sequence. Make sure to
use the correct torque. Refer to
LB348SI on page 11 .
510 - 001 -
LB248S , LB253S,
LB248S , LB253S,

7.10 Mulch door and frame

7.10.1 To disassemble the mulch door and frame
1. Remove the nuts and bolts. Pull the frame and the
mulch door up.
7.10.2 To assemble the mulch door and frame
1. Assemble in the opposite sequence. Make sure to
use the correct torque. Refer to
LB348SI on page 11 .

7.11 Wires

7.11.1 Wires overview
1. Engine brake wire
2. Throttle wire
3. Screw
LB248S , LB253S,
10 1
10 3
10 1
10 2
Repair instructions - 21