Husqvarna LB248S Workshop Manual page 19

2. Remove the engine brake wire from the lever on the
engine.
3. Remove the blade. Refer to
blade on page 15 .
4. Remove the 2 screws. Remove the belt cover.
Remove the blade support.
510 - 001 -
To disassemble the
5. Remove the belt from the belt pulley. Remove the
belt pulley. Remove the 4 bolts. Remove the engine.
7.7.2 To assemble the engine
1. Assemble in the opposite sequence. Make sure to
use the correct torque. Refer to
LB348SI on page 11 .
7.7.3 To do a test of the engine brake
• Do a test of the engine brake after an engine change
to make sure it operates correctly.
• Do a test of the engine brake after an engine brake
wire change to make sure it operates correctly.
1. Make sure the lever arm of the engine brake go
back fully when you push the engine brake handle
down.
2. Make sure that the blade stops in less than 3
seconds after releasing the engine brake handle.
LB248S , LB253S,
Repair instructions - 19