Husqvarna LB248S Workshop Manual page 7

3. Fold the handle forward.
4. Remove the grass catcher.
3.1.4 To set the product in operation position
1. Move the knobs to the lower end of the grooves on
the left and the right side of the product.
510 - 001 -
2. Lift the handle to upright position.
3. Set the handle height in one of the 2 available
positions on the ends of the handle. Make sure to
set the same height on both sides.
4. Move the knobs up in the direction of the handle
until they stop at the top of the groove in the handle.
5. Tighten the knobs fully.
3.1.5 To set the cutting height
The cutting height can be adjusted in five levels.
1. Move the cutting height lever rearward to increase
the cutting height.
Prepare and do servicing on the product - 7