Sanus Systems VMFL1 Assembly Instructions

Download this manual

Assembly Instructions for Model: VMFL1

Thank you for choosing a Sanus Systems Vision Mount wall mount. The VMFL1 is designed to mount up to 30" [76.2 cm] LCD flat panel

televisions weighing up to 40 lbs [18 Kg] to a vertical wall. It will allow the television to be just 0.5" [12.7 mm] from the wall.

WARNING: If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified

contractor or contact Sanus at 800.359.5520 or www.sanus.com. Check carefully to make sure that there are no missing or defective

parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replacement

parts for products purchased through authorized dealers will be shipped directly to you. Never use defective parts. Improper installation

may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified by Sanus Systems. Sanus

Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please call Sanus

Systems before returning products to the point of purchase.

Required Tools: 3/8 or 1/8 drill bit, phillips screwdriver

Supplied Parts and Hardware: (All threaded fasteners are shown full size.)

Wall Plate - A

Monitor Bracket - B

Qty. 1

Lag Screw - C

Dry Wall Anchor - D

Qty. 2

Qty. 4

M4 x 10 mm Bolt - E

M4 x 20 mm Bolt - F

M4 x 30 mm Bolt - G

M5 Locking Bolt - H

Qty. 4

Qty. 2

M4 Washer - I

Small M4 Spacer - J

Large M4 Spacer - K

M5 Spacer - L

Qty. 4

Qty. 2

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 02.23.06 (000026)

Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com

Page 1 Assembly Instructions for Model: VMFL1 Thank you for choosing a Sanus Systems Vision Mount wall mount. The VMFL1 is designed to mount up to 30” [76.2 cm] LCD flat panel televisions weighing up to 40 lbs [18 Kg] to a vertical wall. It will allow the television to be just 0.5” [12.7 mm] from the wall.
Page 2 Step 1: Hang Wall Plate NOTE: Make sure the Wall Plate (A) is oriented so the flat surface in the center of the plate is against the wall as shown in Diagram 1A. Wood Stud Mounting: Using a high quality stud sensor to locate a stud: then, using the Wall Plate (A) as a template mark two holes in the appropriate location, making sure the hole is in the center area of the stud.
Page 3 Step 3: Attach Monitor Bracket to flat back TV To attach the Monitor Bracket (B) to the TV, insert a M4 x 10 mm Bolt (E) through the countersunk hole in the Monitor Bracket, and the M4 Washer (I); then, thread it into the TV. Repeat this until all four bolts are secured to the TV, as shown in Diagram 3. Tighten each M4 x 10 mm Bolt with a phillips screw driver.
Page 4 Tighten both M5 Locking Bolts (H) to secure the Monitor Bracket (B) to the Wall Plate (A). Diagram 7A Diagram 7B Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 02.23.06 (000026) Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com...