Sanus Systems VMFL1 Assembly Instructions page 2

Step 1: Hang Wall Plate
NOTE: Make sure the Wall Plate (A) is oriented so the flat surface in the center of the plate is against the wall as shown in
Diagram 1A.
Wood Stud Mounting:
Using a high quality stud sensor to locate a stud: then, using the Wall Plate (A) as a template mark two holes in the appropriate location,
making sure the hole is in the center area of the stud.
Pre-drill a 1/8" hole 2.5" [63.5 mm] deep where the upper Lag Screw (C) will be installed; then, secure the Wall Plate (A) to the stud using
one of the Lag Bolts as shown in Diagram 1A.
Verify that the Wall Plate is level; then pre-drill a 1/8" hole 2.5" [63.5 mm] deep for the lower Lag Screw (C) and secure the bottom of the
Wall Plate (A) with the second Lag Screw as shown in diagram 1A.
Drywall Installation:
Position the Wall Plate (A) in the desired location on the wall; then, use the Wall Plate as a template and mark the location of the four
outer mounting holes.
Using a 3/8 drill bit, proceed to drill a 3/8
"
Install a Dry Wall Anchor (D) in one of the pilot holes and tighten the Anchor Bolt until it is fully seated as shown in Diagram 1B.
NOTE: Make sure the Washer is between the head of the Anchor Bolt and the Wall Plate (A) as shown in Diagram 1C.
Loosen the Anchor Bolt approximately 1/4
mounted onto the wall, verify that it is level; then, proceed to tighten all four Anchor Bolts.
Diagram 1A
Level
A
C
Step 2: Install M5 Locking Bolts
Insert both M5 Locking Bolts (H) through a M5 Spacer (L); then, thread the M5 Locking Bolts into the Monitor Bracket (B) just enough to
engage the threads as shown in Diagram 2.
pilot hole in each marked location.
"
and repeat the above process for the three additional pilot holes. Once Wall Plate (A) is
"
Diagram 1B
Insert
Dry Wall
Anchor (D)
Tighten Bolt
Until Anchor
is against wall
Diagram 2
Diagram 1C
Drill 3/8"
Pilot Hole
A
B
L
H
Level
Washer must
be between
Anchor Bolt
and
Wall Plate (A)