Sanus Systems VMFL1 Assembly Instructions

Step 6: Attach Monitor Bracket to Wall Plate
Lift the TV up so the two hooks on the Monitor Bracket (b) align with the slits on the top of the Wall Plate (a). See the Detailed View of
Diagram 6 for assistance. Ensure the Monitor Bracket and Wall Plate are secured together by the top two hooks.
Note: Do not tighten Locking Bolts (h) at this point!
Diagram 6
Step 7: Cable hook up and lock Monitor Bracket to Wall Plate
To allow for greater space between the wall and your display to install cables, allow the display to hang from the two top hooks on the
Monitor Bracket (b) with the bottom tabs free to move as shown in Diagram 7a. Once all cables are installed, make sure the top two
hooks and the bottom two tabs are engaged with the wall plate. See the Detailed View of Diagram 7b. Proceed to tighten the M5 Locking
Bolt (h) so the Monitor Bracket is secured to the Wall Plate.
Diagram 7a
a
b
wall
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 04.27.05
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Detailed View
hook
b
tab
h
a
Diagram 7b Detailed View
TV
Thank you for choosing a Sanus Systems Vision Mount wall mount. The VMFL1 is designed to mount up to 30" LCD flat panel televi-
sions weighing up to 40 lb to a vertical wall. It will allow the television to be just .5" from of the wall.
Safety Warning: If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified
contractor or contact Sanus at 800.359.5520 or www.sanus.com. Check carefully to make sure that there are no missing or defective
parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replace-
ment parts for products purchased through authorized dealers will be shipped directly to you. Never use defective parts. Improper instal-
lation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified by Sanus Systems.
Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please call
Sanus Systems before returning products to the point of purchase.
wall
RequireTools: 3/8 drill bit, phillips screw driver
Supplied Parts and Hardware: Some parts not shown as actual size*
h
(4) M4 x 10 mm Bolt - e
l
(4) M4 Washer - i
Assembly Instructions for Model: VMFL1
(1) Wall Plate - a*
(2) Lag Bolt - c
(4) M4 x 20 mm Bolt - f (4) M4 x 30 mm Bolt - g
(4) Small M4 Spacer - j (4) Large M4 Spacer - k
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 04.27.05
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
(1) Monitor Bracket - b*
(4) Dry Wall Anchor - d
(2) M5 Locking Bolt - h
(2) M5 Spacer - l