Sanus Systems VMFL1 Assembly Instructions page 3

Step 3: Attach Monitor Bracket to flat back TV
To attach the Monitor Bracket (B) to the TV, insert a M4 x 10 mm Bolt (E) through the countersunk hole in the Monitor Bracket, and the
M4 Washer (I); then, thread it into the TV. Repeat this until all four bolts are secured to the TV, as shown in Diagram 3. Tighten each
M4 x 10 mm Bolt with a phillips screw driver.
Step 4: Attach Monitor Bracket to a TV with a recessed hole pattern
To attach the Monitor Bracket (B) to the TV, insert a M4 x 20 mm Bolt (F) through the countersunk hole in the Monitor Bracket, and the
Small M4 Spacer (J); then, thread it into the TV. Repeat this until all four bolts are secured to the TV as shown in Diagram 4. Tighten each
M4 x 20 mm Bolt with a phillips screw driver.
Step 5: Attach Monitor Bracket to a TV with a deeply recessed hole pattern
To attach the Monitor Bracket (B) to the TV, insert a M4 x 30 mm Bolt (G) through the countersunk hole in the Monitor Bracket, and the
Large M4 Spacer (K); then, thread it into the TV. Repeat this until all four bolts are secured to the TV as shown in Diagram 5. Tighten each
M4 x 30 mm Bolt with a phillips screw driver.
Diagram 3
I
Diagram 4
J
Diagram 5
K
B
E
B
F
B
G